Page MenuHomeFeedback Tracker
Create Task
Maniphest T84085

Toggle Verticle Mode isn't working properly
Closed, ResolvedPublic
Actions

Description

Am trying to align an object to lie flat to sea-level NOT to the terrain... i.e. a fence panel.

However Toggle verticle mode seems to straighten it correctly until it gets down to a certain height above ground then it just snaps to terrain again.

Details

Legacy ID
3777774176
Severity
None
Resolution
Open
Reproducibility
Have Not Tried
Operating System
Windows 7
Category
Eden Editor
Steps To Reproduce

Select "Toggle Verticle Mode" select "Toggle Surface Snapping" to allow it to go down below surface level and move the object up and down. It will conform to the terrain - incorrectly

http://i.imgur.com/2M5mBAU.jpg

Event Timeline

serjames edited Steps To Reproduce. (Show Details)Sep 22 2015, 9:53 PM
serjames set Category to Eden Editor.
serjames set Reproducibility to Have Not Tried.
serjames set Severity to None.
serjames set Resolution to Open.
serjames set Legacy ID to 3777774176.May 8 2016, 12:45 PM
Waffle_SS added a comment.Sep 22 2015, 11:02 PM

Right click > Transform > snap to... will over-ride this, still seems like this shouldn't happen.

Killzone_Kid added a comment.Sep 22 2015, 11:11 PM

Confirmed, those toolbar switched dont seem to do anything

Adanteh added a comment.Sep 23 2015, 4:21 AM

http://feedback.arma3.com/view.php?id=25743 just made pretty much duplicate ticket. It's when the center of the vehicles goes below terrain level that it automatically switches back to surface alignment.

LouMontana closed this task as Resolved.Jun 28 2021, 12:53 PM
LouMontana updated the task description. (Show Details)
LouMontana edited Steps To Reproduce. (Show Details)
LouMontana set Operating System to Windows 7.
© Bohemia Interactive a.s. Bohemia Interactive® is a registered trademark of Bohemia Interactive a.s. All rights reserved. · Privacy Policy · Terms and Conditions