Page MenuHomeFeedback Tracker

Aiming through scopes/sights is possible with weapon down.
Closed, ResolvedPublic

Description

Well, when I lower my weapon with CTRL+CTRL and I aim, it brings up my weapon, and I can see through my sights like normal. However, when I start walking with my gun down, and then aim, it shows through my scope, except that my view is fixed on the floor, as if my solider was bending over to look through it. With red-dot or bare iron sights my view lowers as if aiming, and the DOF effect is rendered, but the actual gun isn't raised at all. After looking though a scope/sight like this, my solider started walking without any input. All I could do was move and turn, I couldn't go into my inventory, or crouch, or stop or anything at all. The only way to stop it is to switch weapons. Although its a pretty obscure problem, I'd like to see it fixed. {F17705}

Details

Legacy ID
527354648
Severity
Minor
Resolution
Open
Reproducibility
Always
Category
Movement
Steps To Reproduce
  1. Lower your weapon with CTRL+CTRL
  2. Start walking
  3. Right click to aim through your sights
  4. Right click to exit sights

PS. Switch your weapon to stop moving

Event Timeline

DrRumpPhD edited Additional Information. (Show Details)
DrRumpPhD set Category to Movement.
DrRumpPhD set Reproducibility to Always.
DrRumpPhD set Severity to Minor.
DrRumpPhD set Resolution to Open.
DrRumpPhD set Legacy ID to 527354648.May 7 2016, 12:04 PM
skadog added a subscriber: skadog.May 7 2016, 12:04 PM

This happened to me today as well, I couldn't figure out what was happening before I was shot up and killed. It's was very frustrating, I hope it gets sorted out soon.

ceeeb added a subscriber: ceeeb.May 7 2016, 12:04 PM
ceeeb added a comment.Apr 7 2013, 12:25 AM

Duplicate of #739