Page MenuHomeFeedback Tracker

ATOG 6x48 Scope not saving its state correctly
Confirmed Internally, NormalPublic

Description

Since the big ATOG scope can switch between 2 different sights it would be nice if the last state would be remembered correctly. However if you for example look through the long range scope and put the gun away and then use a different gun with iron sights, the next time you take out the gun with the ATOG attached you will look through the close range sight, which makes it kind of unreliable and a little bit inconvenient to use.

Details

Severity
Tweak
Resolution
Open
Reproducibility
Always
Operating System
Windows 10 x64
Category
General
Steps To Reproduce
  1. Take out gun with ATOG 6x48 Scope attached.
  2. Look through the long range sight.
  3. Put the gun away.
  4. Take out a different gun with no scope and aim with iron sights.
  5. Put away the gun with no scope attached and take out the original weapon with ATOG scope.
  6. Aim down sight.
Additional Information

EDIT: This is not exclusive to the ATOG 6x48, but happens with any optics with 2 different sights.

Event Timeline

monomk created this task.Jan 17 2024, 1:36 AM
Geez changed the task status from New to Awaiting internal Testing.Jan 17 2024, 11:00 AM
monomk edited Additional Information. (Show Details)Jan 18 2024, 2:30 AM
Geez changed the task status from Awaiting internal Testing to Confirmed Internally.Jan 19 2024, 10:44 AM