Setting High Command to enable chain of command makes subordinate groups of subordinates (see picture 3) only have their group leader move (see picture 1).
pic 1
pic 2
Description
Description
pic 2
Details
Details
- Severity
- Trivial
- Resolution
- Open
- Reproducibility
- Always
- Operating System
- Windows 10 x64
- Category
- AI Control / Commanding
Steps To Reproduce
- Place down units and configure modules according to picture:
pic 3
pic 4
- Start mission
- Access High Command menu (ctrl-space)
- Give move order
Additional Information
ArmA Version: 1.80.143869 (Stable branch)
Repro: 100% (3/3) in 3den editor
Observed:
Killing the original group leader makes the rest of the group move once another unit has assumed command (see picture 2, note how one group has reached waypoint significantly quicker.)
Once the group leaders(separated from the rest of the group) reaches their waypoints, the rest of the group starts moving into formation (see picture 2).
Issuing a new move order while units are moving into position causes non-leader units to stop on the spot.
Event Timeline
Comment Actions
I just tested this in our Dev Branch and it works could you please test this in the Dev Branch if the issue is present? Also did you use set waypoint or a different command?
Comment Actions
I am unfortunately unable to test it in dev branch currently, though here's the mission.sqm.
I did use set waypoint, and also tried changing the waypoint properties.