The red curve and preview animation don't show up for the new keyframe animation system.
Followed this tutorial:
https://community.bistudio.com/wiki/Arma_3_Key_Frame_Animation:_Tutorial_-_3DEN
Description
Description
Details
Details
- Severity
- Major
- Resolution
- Open
- Reproducibility
- Always
- Operating System
- Windows 10
- Category
- Eden Editor
Steps To Reproduce
- Place Timeline module
- Tick "Play From Start", set length to 15 seconds, tick "Loop"
- Place Rich Curve module and sync to Timeline module
- Set Orientation Mode to Animation
- Place two Rich Curve Keys, sync both to Rich Curve
- Select one Rich Curve Key, and set Time to 15
(The preview should show up, but doesn't)
- Add any object, and sync to Rich Curve module
(The object should snap to the animation preview, but doesn't)
Additional Information
Although the preview doesn't show up, the animation does work when playtesting.
Replicated on a fresh installation of Arma 3, tested on Tanoa and in VR.
A comment on Voytek's tweet that was in the status report confirms i'm not alone!
Event Timeline
Comment Actions
I checked it for DEV yesterday. Everything worked for me.
The red line of a trajectory appears only when you begin to change the provision Rich Curve Key or Control Points.
https://forums.bistudio.com/forums/topic/210987-keyframe-animation-system-in-dev/?tab=comments#comment-3253893