Page MenuHomeFeedback Tracker
Create Task
Maniphest T84163

Editing waypoint position from the attributes dialog does not move the waypoint
Closed, ResolvedPublic
Actions

Description

After placing a waypoint, then editing its position attributes through the attributes dialog, the waypoint remains on the old position, while the dialog saves your position data.

Details

Legacy ID
3461211503
Severity
None
Resolution
Fixed
Reproducibility
Always
Category
Eden Editor
Steps To Reproduce
  1. Open EDEN Editor and place a Rifleman
  2. Add a waypoint for him nearby
  3. Open the waypoints attributes
  4. Edit the waypoint position to X:1, Y:1, Z:1 and click OK
  5. Observe that the waypoint did not move
  6. Open the waypoints attributes again
  7. Observe that the dialog shows the position you previously entered
  8. Exit the attributes dialog and move the waypoint by dragging it
  9. Open the waypoints attributes again and observe that the waypoint position is now updated to the position you moved it to

Event Timeline

Sniperwolf572 edited Steps To Reproduce. (Show Details)Sep 24 2015, 6:52 PM
Sniperwolf572 set Category to Eden Editor.
Sniperwolf572 set Reproducibility to Always.
Sniperwolf572 set Severity to None.
Sniperwolf572 set Resolution to Fixed.
Sniperwolf572 set Legacy ID to 3461211503.May 8 2016, 12:47 PM
sadovsf added a comment.Sep 25 2015, 10:11 AM

Hello! :)
Thank you for your report. I'am going to take a look on it right now ;)

sadovsf added a comment.Sep 25 2015, 10:22 AM

So i found an issue and it is fixed now ;) you can check it out in tuesday DEV update :)
Have a nice day...

© Bohemia Interactive a.s. Bohemia Interactive® is a registered trademark of Bohemia Interactive a.s. All rights reserved. · Privacy Policy · Terms and Conditions