Page MenuHomeFeedback Tracker

Functions Viewer not opening like before
New, NormalPublic

Description

While on 3DEN I like to access the Functions Viewer to recompile specific functions on the fly so I can swiftly test my codes. However, since the last update Functions Viewer no longer opens with my last "viewed" function opened. I keep having to re-filter the lefthand dropdown menus to have the functions listed and only then I can select my function again and recompile.
Not sure if this was intentional, but is seriously maddening.

Details

Severity
Tweak
Resolution
Open
Reproducibility
Always
Operating System
Windows 10 x64
Category
Menu UI
Steps To Reproduce
  1. Open a custom mission with some functions added to CfgFunctions in 3den Editor;
  2. Click "Tools" > "Functions Viewer";
  3. Filter them out on the left side dropdown menus and select any function to have it displayed on the righthand text box;
  4. Close the Functions Viewer;
  5. Now open Functions Viewer again. The dropdown menus are still filtered out, but no functions are listed below, nor their content are displayed on the right;
Additional Information

Before the update you would open Functions Viewer and immediately see your last seen function content, as well as having access to the recompile-ish buttons on the bottom of the screen.

Event Timeline

SergioNunes edited Steps To Reproduce. (Show Details)

Have this issue too.