Page MenuHomeFeedback Tracker

Abrams left rear tow ring is slightly offset from its mounting point
Closed, ResolvedPublic

Description

This is just about the tiniest, most useless nitpick in the world. But I'm still gonna report it.

On the CSLA M1 and M1IP, the left rear tow ring is slightly offset from the thing it attaches to on the main model. This results in a small gap between the tow ring model and the main model.

This has absolutely no effect on the gameplay - but it's a total "once you see it, you can't unsee it" thing, and hopefully a simple fix.

Details

Severity
Trivial
Resolution
Open
Reproducibility
Always
Operating System
Windows 10 x64
Category
Visual-Vehicles
Steps To Reproduce

Place a CSLA M1 or M1IP in the Editor.
Open it in the Virtual Garage and turn on the "Rear tow rings" component.
Rotate the camera to look at the rear tow ring on the vehicle's left side. Note that there is a small gap between the tow ring and the hardpoint it's attached to, on one side. Compare the right-hand tow ring which has no gap.

Event Timeline

NikkoJT created this task.Dec 3 2021, 2:12 PM
Lukyy changed the task status from New to Acknowledged.Dec 5 2021, 12:32 PM
Lukyy moved this task from Backlog to Internal FT on the Arma 3 Creator DLC - CSLA Iron Curtain board.
Lukyy added a subscriber: Lukyy.

Thank you for the report, we'll look on it.

Lukyy lowered the priority of this task from Normal to Low.Dec 5 2021, 12:33 PM
This comment was removed by Geez.
Geez added a subscriber: Geez.Dec 9 2021, 10:08 AM

This critical issue was resolved in CSLA 1.1.

Lukyy closed this task as Resolved.Nov 12 2022, 11:56 AM
Lukyy claimed this task.