Page MenuHomeFeedback Tracker

Rotor instantly goes full speed when entering a helicopter with Advanced Flight Model enabled
Confirmed Internally, NormalPublic

Description

When you turn off the engine of a helicopter and get out, with Advanced Flight Model enabled, and you enter again before the rotor has fully stopped, it'll instantly go to full speed and spin down all over again.

Details

Severity
Minor
Resolution
Open
Reproducibility
Always
Operating System
Windows 10 x64
Category
Advanced Flight Model
Steps To Reproduce

In the editor

  1. Place a blackfoot in the air and preview the mission
  2. Make sure Advanced Flight Model is enabled.
  3. Land the helicopter
  4. Get out and let the rotor spin down
  5. At any time before it has completely stopped rotating, get back in as pilot and it will instantly jump back to full speed, spinning down again. Can be repeated until the rotor fully stops.
Additional Information

Event Timeline

MulleDK19 edited Additional Information. (Show Details)Mar 24 2017, 9:00 AM

This still happens.

Wulf changed the task status from New to Confirmed Internally.Jan 15 2018, 7:02 PM