Page MenuHomeFeedback Tracker

Bandages didn't stop bleeding after zombie hit
New, WishlistPublic

Description

I was bleeding after a zombie attacked so I tried to use bandages. I had 2 bandages and I used both. Still blood poured out. I didn't see bandaging animation, but I heard the bandaging sound and they were both used from my inventory.
I ran around until I found a t-shirt which I tore to rags. Again I used a rag and continued bleeding so instead of using them all, I removed old rags (quantity 0) from inventory and put my newly made rags in place. I fiddled around with them until finally I could see rags in my hand (I tried to put rags to my hand slot before, too, but it didn't work that time). When rags were shown in hand they worked perfectly and bleeding stopped. Then I was pludgeoned to death from behind. The end.

Details

Legacy ID
81170569
Severity
None
Resolution
Open
Reproducibility
Sometimes

Event Timeline

AlBobo set Category to category:items.Dec 18 2013, 4:58 PM
AlBobo set Reproducibility to Sometimes.
AlBobo set Severity to None.
AlBobo set Resolution to Open.
AlBobo set Legacy ID to 81170569.May 8 2016, 2:27 PM
Venge added a subscriber: Venge.May 8 2016, 2:27 PM
Venge added a comment.Dec 19 2013, 6:15 PM

I experienced the same thing.

I had been hit by a zombie and was bleeding, I finished off the zombie and bandaged, I then noticed I was still bleeding. I tried using my bandages 3 more times, until I passed out and died, and each time it would say "The bleeding has stopped" immediately followed by the "You feel warm blood" or whatever then indication was.

I had already bandaged previously with both rags and bandages in the same life and it worked so not sure if it might have something to do with that.

I've been hit by a zombie and started bleeding. I saw "Bleeding" in my inventory then I used a bandage. In the chat log I could see "You are no longer bleeding" and the indication in my inventory disappeared but I could still see the animation on my character and hear the moans.
I had to disconnect, then reconnect to fix it.