Page MenuHomeFeedback Tracker
Create Task
Maniphest T76361

A-164 Trim/xt-Axis incorrectly configured
Closed, ResolvedPublic
Actions

Description

Try and fly the A-164 and the nose will keep pulling down.

Check the Air/Sea HUD and its position is incorrect as well which makes me think the Center trim is incorrectly placed.

This creates a massive problem when doing CAS runs as the aircraft is not stabilized and your cross-hairs bounce all over the place.

Details

Legacy ID
2825334455
Severity
None
Resolution
Duplicate
Reproducibility
Always
Category
Movement
Steps To Reproduce

Place A-164.

Jump in

Fly Jet

Event Timeline

SpamIrwin edited Steps To Reproduce. (Show Details)Mar 21 2014, 3:41 AM
SpamIrwin edited Additional Information. (Show Details)
SpamIrwin set Category to Movement.
SpamIrwin set Reproducibility to Always.
SpamIrwin set Severity to None.
SpamIrwin set Resolution to Duplicate.
SpamIrwin set Legacy ID to 2825334455.May 7 2016, 6:14 PM
SpamIrwin added a subscriber: SpamIrwin.
SpamIrwin added a comment.Mar 21 2014, 7:00 AM

Need Title updated to XY-Axis "T" is a typo

SpamIrwin added a comment.Mar 22 2014, 1:24 AM

Found one way to counter the on-going pulling down of the nose, Put your flaps down, It will slow the aircraft big time but it will stabilize it. The Air Land Hud is still off however and wont stop that.

AD2001 added a subscriber: AD2001.May 7 2016, 6:14 PM
AD2001 added a comment.Mar 26 2014, 12:53 PM

Duplicate of #0017824.

© Bohemia Interactive a.s. Bohemia Interactive® is a registered trademark of Bohemia Interactive a.s. All rights reserved. · Privacy Policy · Terms and Conditions