Exterior Connection Outer Corner dose not sit in place properly when welded
New, NormalPublic

Subscribers
Assigned To
None
Authored By
Salt_lamp, May 30 2017

Description

Ok so you're building a 3 layer type habitat or attempt to and this interior part when welded in place dosen't seem to be placed in the right holes. But this only happens on one side of the habitat I've checked other corners and they are fine.

Details

Severity
Minor
Resolution
Open
Reproducibility
Always
Operating System
Windows 7
Category
General
Steps To Reproduce

have a corner made and then weld the "Exterior Connection Outer Corner" to it. If it looks ok, try turning the corner left or right see if happens from a diffrent angle.

Additional Information

Screenshots for viewing

http://imgur.com/a/Ol2zS

Add Comment