Page MenuHomeFeedback Tracker

Power cable ends stuck in ground(0.9.0107 : 39176)
New, WishlistPublic

Description

Ran into an issue with the power cable ends getting stuck in the ground. Unable to remove them, though I am able to grab them. {F33221}

Details

Legacy ID
3076474002
Severity
None
Resolution
Open
Reproducibility
Sometimes
Steps To Reproduce

Both times it occurred when the cable reel was on its side. It appears to occur when the cable ends are on the bottom when you release a new cable.

Event Timeline

Bohemia added a project: Restricted Project.May 9 2016, 9:59 AM
rebelgamer set Category to category:bugs.
rebelgamer set Reproducibility to Sometimes.
rebelgamer set Severity to None.
rebelgamer set Resolution to Open.
rebelgamer set Legacy ID to 3076474002.May 9 2016, 9:59 AM
zathras added a subscriber: zathras.May 9 2016, 9:59 AM

Respooling the cable helped me.

DLlasa added a subscriber: DLlasa.May 9 2016, 9:59 AM

I found that when i install a device like a solar panel, mmrtg, etc on top of a cable it has a high chance of causing this issue where the cable gets buried into the ground.

on a side note i tried the note (0000929) zathras twice now and have not been able to respool the stuck cable, seems like this may only be a partial work around

Rubik added a subscriber: Rubik.May 9 2016, 9:59 AM

I had three cables stuck in the ground on the Victoria Settlement mission. They were caused by de-spooling the cables with the drum on its side on the ground.
One cable I successfully re-spooled because I hadnt moved the drum much, the first two cables I attempted to re-spool and failed, I tried laying the cable over the drum and they would not respool.
If you grab the end of the cable you can slowly drag the end but it remains stuck in the ground.
I attempted to pop it out of the ground by connecting another cable end to the twitching stuck end, but despite showing the blue hologram of a valid connection it would not connect.

Edit: you must move the middle of the cable up to the drum to respool, if you move the drum to the cable you do not get a respool option.